# Command summary

netcon		- Network console to connect to domain.
netcontool	- GUI version of network console

		  ~. escape
		  ~^ readonly session
		  ~@ unlocked write. possible to take write perm away
		  ~& locked write. unremovable write permission
		  ~* exclusive session. terminate all other sessions

hostview	- GUI configuration tool

hostinfo	- Check Starfire system status

hpost 		- Do POST on a certain domain
bringup		- Bring up a domain

fan		- Control fan speed
power		- Control power to Starfire

ssp_config	- Configure the SSP
ssp_unconfig	- Unconfig the SSP

cb_reset	- Reset/reboot control board
cb_prom		- Upgrade PROM on primary control board

domain_create	- Domain management commands
domain_remove
domain_status
domain_history
domain_switch

obp_helper	- Manage OBP, last 5 versions of eeprom
sys_id		- See hostid information

apdb		- Manage AP database
apboot		- Manage /etc/vfstab and /etc/system for AP
apconfig	- AP configuration tool
apnet		- AP net config tool
apdisk		- AP disk config tool
apinst		- List AP capable IO devices

#
# /etc/system (specific variables)
#
* DR specific variables
set soc:soc_enable_detach_suspend=1
set pln:pln_enable_detach_suspend=1
set kernel_cage_enable=1

* AP specific variables
* Begin AP database info (do not edit)
set ap:apdb_dblist="ssd:36 ssd:92"
* End AP database info (do not edit)

* We may have to do the following in order to boot from fiber
forceload: drv/ssd
forceload: drv/sf
forceload: drv/socal
forceload: drv/sbus

#
# Decoding interface card location (this is E10K specific, Ex500 class has
# different encoding)
#

/sbus@41,0/qec@1,20000/qe@3,0

sbus@41 = system board 0, Sbus 1

   4  1

0100  0001
 ^^----^ ^-- sbus number [0-1]
 |  |
 |  |-- sys board number [0-F]
 |
 |-- 1 = IO
     0 = proc

qec@1 = SBus slot 1

    ^-- SBus slot number [0-1]

#
# Decoding processor location
#

/SUNW,UltraSPARC@1f,0 = system board 7, proc 3

   1  f

0001  1111
 ^^----^^-- processor number [0-3]
 |  |
 |  |-- sys board number [0-F]
 |
 |-- 1 = IO
     0 = proc